5
Disc Sander Spindle and Collet Systems
CHANGING THE SPINDLE TO THE COLLET SYSTEM (MODELS 28547 AND 64874):
1. Remove the Spindle Joint (#26) from the Spindle (#25) using the appropriate open end wrenches.
2. Insert the 4 mm Hex Wrench (#35) through the Spindle to secure the output shaft. Use the open end wrench to loosen the Spindle and remove it from the
output shaft.
3. Attach the Collet Spindle (#28) to the output shaft and tighten using the 4 mm Hex Wrench and the appropriate open end wrench.
4. Insert the Collet (#29) into the Collet Spindle. Attach the Collet Nut (#30) onto the Collet Spindle, but do not tighten completely.
5. Insert the Roloc™ Shank (#31) through the Collet Nut and tighten securely.
