16
78-8122-3169-0-F
b) Internal mounting
uses the 1/2" bolts provided
with the cabinet. The internal mounting holes are
located on the inside flanged portion of the base.
c)
For proper door clearance and operation the
cabinet doors must be square. Shims are provided
for this purpose.
6.4 When the cabinet is in place, remove the lifting straps
bolted to the sides of the cabinet. Replace the bolts
with the carriage-bolt heads to the outside of the
cabinet.
6.5 Identify cabinet (street address) on street side door
according to your company procedure.
Internal Mount
Position
6.6 Reverse the doors and removable back panel to install a 3M
™
Cross-Connect Cabinet 4220 D, E, F, KF, KT or 4230
MF or LF against a wall or obstruction:
Note: Mounting pad requirements are the same.
a)
Remove the doors with the hinges and the door latching system from the front of the cabinet.
b)
Remove the back panel and its supports and attach them to the front of the cabinet using the same hardware.
c)
Attach the door latching system and doors with the hinges to the back of the cabinet. The base access panel
should be on the door side.
d)
Mount the cabinet and do all work through the doors and base access panel.
Note: These cabinets are intended for OSP (Outside Plant) applications only. The cabinets shall not contact the
exterior wall of any building.
Summary of Contents for 4220-ET
Page 31: ...78 8122 3169 0 F 31 ...
