27
90
°
5.7
Jumper Wire Installation and Routing
a.
Jumper wire ends must be clean cut and bent
90˚. The post slot must be in the vertical
insertion position.
b. Split pair, TIP - left, RING - right, at assigned
post positions. Insert the wire into the port and
through the post until the wire extends out the
exit port.
c.
Rotate post 90˚ clockwise with a screwdriver
blade fully inserted into post slot. The cut off
of excess wire indicates a proper connection.
d. To remove jumper wire, rotate post 90˚
counterclockwise.
90
°
Hook
1/2" - 3/4"
RING - right
TIP - left
3" slack
each end
Pair 1
Pair 5
Pair 25
Pair 21
3" slack
each end
e.
Always route jumper wires below the connected post.
