9
7.12 Continuously push PST downward while pulling the rest of the
core material.
7.14 For pedestal closure applications, secure the closure to pedestal,
mount terminal block and connect ground wires according to
system practice.
7.13 When the PST is in place, remove the core wrap from around the
cable.
7.9
Push PST towards bottom of closure. This will invert the PST.
Note: Do not force the PST to slide on the closure during inversion.
7.08 While holding the PST and closure with one hand, unwind the core
by pulling on the core tail with the other hand in an upward and
outward COUNTERCLOCKWISE direction until approximately
0.5"(13 mm) of the PST is shrunk onto the closure.
7.11 Place assembly over splice and onto gel end seal. Insure the
wireform latch and the 3M logo are facing forward.
7.10 Pull the core material from the PST until the PST is even with
the bottom of the closure.
Summary of Contents for 4604
Page 1: ...June 1998 34 7045 6337 7 A Re enterable PST Dome Closure Instructions ...
Page 2: ...2 ...
Page 15: ...15 ...
