13
12.0 Closure Installation – 4608GW and 4608XL-GW
12.1 Remove cardboard insert and pull core tail through the center of PST
until core is even with PST edge.
12.4 Place assembly over splice and onto gel end seal. Insure the wireform
latch and the 3M logo are facing forward. Mate the plate with the base.
12.3 While holding the PST and closure with one hand, unwind the core by
pulling on the core tail with the other hand in an upward and outward
COUNTERCLOCKWISE direction until approximately 2.0" (51 mm)
of the PST is shrunk onto the closure.
12.2 Slide PST over closure so that the PST tail is pointed toward the top of
the closure. The core tail MUST be unwound upward. Position PST
bottom edge within 0.5" (13 mm) of the bottom of the base.
Note:
Optional method is to put closure over the splice bundle and
position PST 2" (51 mm) below the gel end seal. While holding the
PST and closure with one hand, unwind the core by pulling on the
core tail with the other hand in an upward and outward
COUNTERCLOCKWISE direction.
Obsolete
Document
