3M 7700 Series, Preparation Instructions

Steps

3M

™

 Round Conductor Flat, Controlled Impedance Cable, 7700 Series 

Cable Preparation Instructions | 78-9102-5431-3 Rev A

Figure 12

Figure 10

Figure 7

Figure 6

Figure 8

Figure 9

Figure 11

Step 3   

Align

 the cut portion of cable against the right angle guide on the upgraded 

Carpenter Model 47 Cable Stripper. Push forward to make contact with the 

strip length stopper. Lock cable alignment in place using Handle 1. 

Step 9 

Trim

 excess covering using a 

precision utility knife for clearance 

when terminating to 3M

™

 Ribbon 

Cable Wiremount Socket Assembly,  

451 Series, optional. 

Step 4   

Slice

 blades closed using 

Handle 2. 

Step 5   

Rotate

 Handle 3 to remove 

covering. 

Step 6   

Reset

 Handles 2 then 3  

then 1 to starting positions. 

Step 7 

Remove

 sample from 

upgraded Carpenter 

Model 47 Cable Stripper 

and carefully peel off any 

remaining foil covering,  

as necessary. 

Step 8 

Inspect

 sample specimen  

for covering removal and 

insulation damage. 

Step 1 

Set

 blade depth on the 

upgraded Carpenter  

Model 47. See page 1  

“Set blade depth” 

 for details. 

Step 2   

Cut

 3M cable 7700 series  

to the appropriate length, 

using any ribbon cable 

cutter.