ENGLISH
Go to
Main Menu
Go to Operator Guide
Table of Contents
3M 9700 Operator’s Guide
7
Lamp Replacement
Use the proper lamp type for your projector.
FXL 410W 82V
EVD 400W 36V
1. Push power switch to “Off” and unplug projector.
2. Release cover latch and lift up stage cover.
!
Lamp and adjacent metal parts are hot. Allow lamp
to cool before replacing.
3. After lamp has cooled, remove and discard.
a.
FXL Lamps: Pull back on lamp ejection lever
to release. Pull lamp out.
b. EVD Lamps: Lift retaining bracket to open
condenser lens frame. Pull lamp out.
EVD
FXL
4. Push new lamp fully and squarely into socket.
For EVD lamp, do not touch bulb glass with
fingers. Close condenser lens frame and secure
with bracket.
5. Close stage cover and plug in power cord.
Color Tuning
Rotate the colour tuning dial to eliminate the
yellow/orange to brown or blue corners projected on the
screen.
1. Rotate dial to the left to remove blue corners.
2. Rotate dial to the right to remove yellow corners.
AC Electrical Outlets
There are two unswitched AC power outlets, for
powering accessories, connected to a 5 amp circuit
breaker.
Caution
!
Do not overload outlets with accessories that
exceed a total of 5 amps.
To Reset the Circuit Breaker:
1. Unplug accessories and lift stage cover to access
circuit breaker.
2. Push down on circuit breaker lever to reset.
