North American - ENG
Date Released:
10-20-20
3M-Matic
™
Accuglide V HSP - 2 Inch Taping Head - Type 12000
Page 15
44-0009-2157-5 / ECO#0086964
Applying Mechanism Spring
The applying mechanism spring, shown in
Figures 5-4
, controls applying and buffing
roller pressure on the box and returns the
mechanism to the reset position. The spring
pressure is pre-set for normal operation.
One-Way Tension Roller
Figure 5-5
The one-way tension roller is factory
set. When replacing this assembly,
the roller must have 0,5 kg [1 lb.]
min. tangential force when turning.
To Adjust Tension:
1. Wrap a cord or small strap
(non-adhesive) 4-6 turns around
the tension roller.
2. Attach a spring scale to the end of
the cord or strap.
3. Turn adjusting nut (with socket
wrench provided) until required
force of approximately 0.5 kg to
0.9 kg [1 to 2 lbs.] is reached to
turn roller pulling on spring scale.
(Adjustments
continued
on next page.)
Adjustments
(continued)
• To reduce the risk associated with
shear, pinch, and entanglement hazards
- T
urn air and electrical supplies off
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box
drive system is running
Warning
Figure 5-4 Applying Mechanism Spring
Figure 5-5 One-Way Tension Roller
0.5 - 0.9kg
[1 - 2 lbs.]
Adjusting Nut
Summary of Contents for Accuglide V HSP
Page 46: ...38 ...