HARD-STONE LAPIDARY ADD-ON KIT: Item# K-1001 (For Hard and Soft Stones up to 9.5 on the Mohs scale)
FOR CABOCHONS AND FLAT PIECES
TO REMOVE SCRATCHES OR CHIPS
STEP 2
REFINE the shape and
remove scratches:
Use
3M
Microfinishing Diamond
abrasives
to finalize the shape and
remove any leftover scratches.
Speed:
Medium-High speed with water
STEP 3
PREPARE your piece for POLISHING
Prepare your piece for final polish
using
3M
Premium Diamond
abrasives,
the brown discs.
Speed:
Slow Speed
(with lots of water)
Pressure:
Use gentle, consistent pressure.
STEP 1
GRIND and SHAPE your piece
Use
3M
Flex-Diamond
(COARSE ) abrasive
Speed:
High speed with water
FLEX DIAMOND DOES NOT NEED A CUSHION
1
FINAL STEP
HIGH-POLISH your piece.
Use
3M
Cerium Oxide
to get a final polish
WARNING:
Do NOT use on porous surfaces
Speed:
Slow (with lots of water)
Pressure:
Use Use gentle, consistent pressure.
4
ALTERNATE FINAL STEP:
POLISHING
Some stones polish easily with our
FELT DISC
Try this after step
for Turquoise, Opal, etc.
Speed:
High Speed. DO
NOT
USE WATER
ALTERNATE STEP
4
HARD LAPIDARY
Toll Free: 1-85-JOOLTOOL
p.20
Buy supplies at WWW.JOOLTOOL.COM
CLEANING:
Clean abrasives with damp cloth for longer life & performance.
Repairing scratched or chipped pieces is similar to working on raw (rough) material.
For DEEP Scratches: Start at
Step 2c
, then continue up to
FINAL STEP.
For LIGHT scratches: Start at
Step 3a
, then continue up to
FINAL STEP
.
Also try
ALTERNATE FINAL STEP.
FOR ALL STONES, MINERAL CRYSTAL, HARD GLASS
SHAPING & POLISHING STEPS
FELT DISC
I
tem# B-301
2
3
This 4-
Gr
ade K
it I
tem# K
-3600-4
This 4-
Gr
ade K
it I
tem# K
-3650-5
Apply COMPOUND on FELT DISC
Item#: C-103
MAY BE SOLD SEPARATELY
FOLLOW FROM
TOP TO BOTTOM
X Coarse
I
tem# D-36250-1
1
Coarse
Item# D-3074-2
2a
Medium
Item# D-3045-2
2b
Fine
Item# D-3030-2
2c
Very Fine
Item# D-3020-2
2d
3000 Grit
Item# D-33000
3a
8000 Grit
Item# D-38000
3b
50 000 Grit
Item# D-50000
3c
FINAL STEP:
Cerium Oxide
Item# AT-13000-2
4
Apply CUSHIONS to BACKPADS.
FLEX DIAMOND & FELT don’t need cushions
Apply abrasives onto BACKPADS
(with the CUSHIONS applied).
Use Water Tray to apply water to the
workpiece during every step.
SETUP
1
2
3
SAFETY FIRST!
Always wear eye
and respiratory
protection.
ANIE’S TIP:
To avoid scratches on finished piece, follow ALL steps THOROUGHLY & inspect your piece after each step.
2d