STEP 1
SHAPE your clay
Use
3M
Microfinishing Film
15 Mic. (Orange/Translucent)
Hold the piece FLAT against the spinning abrasive.
Speed:
Medium / Low Speed
1
STEP 2
REMOVE Scratches
Use
3M
Microfinishing Film
9 Mic. (Translucent abrasive)
Hold the piece FLAT against the spinning abrasive.
Speed:
Low Speed
2
STEP 3
Refine the surface to produce a smooth satin finish
Use the
FELT DISC
WITH COMPOUND
.
Make FLAT contact, then move piece to polish desired areas.
SPEED:
Very Low Speed
TIP:
Higher speeds remove material!
The speed determines the amount of material that is polished off.
3
STEP 4
BUFF your clay
Use
Buffing Wheel
with
LIGHT PRESSURE!
DO NOT PUSH
hard against the edge of the spinning Buff.
Speed:
High Speed, Finish with Slow Speed.
DO NOT USE COMPOUND!
4
FOLLOW FROM
TOP TO BOTTOM
“FLAT” POLYMER CLAY & RESIN
FOR FLAT OR DETAILED PIECES
SHAPING & POLISHING STEPS
Toll Free: 1-85-JOOLTOOL
p.22
Buy supplies at WWW.JOOLTOOL.COM
STEP 1
SAND your clay
Use
3M
Radial Brushes
(Pumice -Pink)
Gently hold the pice against the outer EDGE of the brush.
Speed:
High Speed
STEP 3
POLISH your clay
Use the
Buffing Wheel
WITH
COMPOUND
Use
LIGHT PRESSURE! DO NOT PUSH HARD
on buff.
Speed:
High Speed
TIP:
The speed affects the amount of
material that is polished off.
STEP 4
BUFF your clay
Use the CLEAN
Buffing Wheel
WITHOUT
COMPOUND
Use
LIGHT PRESSURE! DO NOT PUSH HARD
on buff.
Speed:
High Speed
REMINDER: DO
NOT
USE COMPOUND FOR THIS STEP (4)!
STEP 2
PRE-POLISH (OPTIONAL)
Use
3M
Radial Brushes
(6 & 1 Micron - Peach and Green)
Hold the piece against the edge of the spinning brush.
Speed:
High Speed
1
4
2
3
Apply CUSHIONS to BACKPADS.
FELT & BUFF don’t need cushions.
Apply abrasives onto BACKPADS
(with the CUSHIONS applied).
Prepare FELT DISC as shown in your
USER’S GUIDE and VIDEO
SETUP
1
2
3
SAFETY FIRST!
Always wear eye
and respiratory
protection.
IMPORTANT:
Stay within your see-thru area of the disc.
Avoid using the edge to prevent cutting grooves in the clay.
FINE 15 Mic
I
tem# AM-13015-6
1
FLAT PIECES
FOR DETAILED PIECES
VERY FINE 9 Mic
I
tem# AM-13009-3
2
FELT DISC
I
tem# B-301
3
BUFFING WHEEL
I
tem# B-9335
4
FOLLOW FROM
TOP TO BOTTOM
Pumice (pink)
I
tem# R-343-PUM
1
BUFFING WHEEL
I
tem# B-9335
3
BUFFING WHEEL
I
tem# B-9335
4
6 Micron
I
tem# R-342-6
2a
1 Micron
I
tem# R-341-1
2b
Use with COMPOUND
Item#: C-103
+
Use with COMPOUND
Item#: C-103
+
POLYMER CLAY ADD-ON KIT: Item# K-1005