3M™ AT9000 MK2 Full Page Reader User Guide
Installing
the Reader
Power on the reader
To power on the reader press the power switch located on the back of the reader for approximately 0.5
second.
A power-on self-test occurs automatically when the reader powers up. If the reader is installed correctly
and is operational, the indicator lights will perform the following boot-up sequence:
•
All lights come on briefly at initial power-up.
•
During power-up self test the OK light (green) remains on while the Ready light (blue) flashes.
•
After approximately 10 seconds, the Ready light (blue) remains on and all other lights turn off
The lights may also indicate the following common communication errors:
•
The blue Ready light flashes rapidly if no USB connection is detected.
•
The blue Ready and red Error lights flash rapidly if a USB 1.1 connection is detected. The reader
will not transfer document images over a USB 1.1 connection. However, contactless and contact
chip reading will function over a USB 1.1 connection.
Test the reader installation
After installing the reader, perform a quick test to ensure the reader is functioning properly and the
software was installed correctly.
To test the reader:
1. Start the application
Page Reader Expo
from the shortcut created during software installation.
2. Select a scheme that matches your reader. If you are unsure, select the “ePassport and Images”
scheme.
3. Click
Select
.
4. Verify that the Ready light (blue) is on and the Reader State in the lower left is “Enabled”.
The reader is ready to accept documents.
5. Select the test card (DS-00031 or DS-00034) supplied with the reader.
Copyright 2018 IDScience Inc. Rev. 20180725
