8
3M™ Multi-Touch Chassis Display User Guide
3M Touch Systems, Inc. Proprietary Information -- 37732v04
CAUTION
To avoid the potentially hazardous situations associated with the use of alcohol or
other solvents which may result in minor or moderate injury or property damage:
•
Follow all instructions and recommendations in the manufacturer's Material Safety
Data Sheet and product label.
•
Be sure to follow solvent manufacturer's precautions and directions for use when using
any solvents
•
It is important to avoid using any caustic chemicals on the touch sensor. Do not use
any vinegar-based solutions.
To avoid possible environmental contamination which may result in minor or
moderate injury:
•
The lamp(s) inside this product contain mercury (Hg) and must be recycled or disposed
of in accordance with local, state, or federal laws. Check your individual state's
requirements to see if specific recycling requirements exist for mercury-containing
products or other electronic products. Refer to
http://www.nema.org/lamprecycle/
or
call 3M Touch Systems 1-866-407-6666 for further information.
•
Dispose of the flat panel display according to applicable governmental regulations
.
Important Notes
•
In extreme temperature and humidity situations, you may observe condensation
between the touch screen and the display. To minimize this condition, place the unit
where it will be used and allow a 24-hour environmental stabilization period prior to
powering on the display. Any noticeable condensation is temporary and will have no
long term affect on the operation of the display.
•
You are cautioned that any change or modification to the equipment not expressly
approved by the party responsible for compliance could void your authority to
operate such equipment.
•
When unplugging the power supply cord, hold the plug, do not pull by the cord.
•
Do not connect or disconnect this product during an electrical storm.
•
Remember to take into account that the operating temperature of the installation may
be greater than the room ambient, and consideration should be given to installing the
unit in an environment compatible with the maximum rated operating temperature.
Specifications can be found in the product data sheet on the 3M Touch Systems
website at
http://www.3m.com/touch/
.
•
When installing the unit, ensure that it does not restrict the flow of air to any other
equipment within the installation required for safe operation.
•
An inherent characteristic of the PCT sensor is a fine grid pattern that may be visible
under certain lighting conditions.
•
Install the display in a well-ventilated area. Always maintain adequate ventilation to
protect the display from overheating and to ensure reliable and continued operation.
•
Do not expose this display to direct sunlight or heat. Passive heat may cause damage
to the housing and other parts.
