12
78-81
41-4631
-
8
-
A
Note:
In applications where the splice is regularly exposed to high levels of ultra-violet radiation
(i.e. direct sunlight), wrap two half-lapped layers of
Schotch®
Super
33+™ Vinyl Electrical Tape or
Schotch® V
inyl
Electrical T
ape
Super 88
over the re-jacketing tubes.
Note:
If circuit grounding is required at this splice location, connect to the ground wire per
Wisconsin Electric specifications.
2.5
Connect Neutral Wires for CN Splices
For CN to CN Splices
2.5.1 Route neutrals straight across splice body and secure using vinyl tape.
Neutrals straight across splice
2.4.3 Continue to install the cold shrink tube over the rubber mastic on the other cable by slowly pulling and
unwinding the outer core counterclockwise. This portion of the cold shrink tube installs differently than
typical cold shrink products in that as the tube shrinks, the end rolls under. The tube may need a slight
push to get over the second mastic seal.
completed splice
