14
78-81
41-4631
-
8
-
A
For CN to CN Splices
2.6.4
For exposed neutral connection:
Route neutrals over splice and connect. Include two wires routed
under splice jacket.
Note:
In applications where the splice is regularly exposed to high levels of ultra-violet radiation
(i.e. direct sunlight), wrap two half-lapped layers of Scotc
h® Super 33+™ Vinyl Electrcal Tape
or
Scot
ch® Vinyl Electrical Tape
Super 88
over the re-jacketing tubes.
2.6.2 Begin to install the cold shrink tube by completely covering the rubber mastic, and slowly pulling and
unwinding the inner core counterclockwise toward the splice body. The outer core should remain relatively
stationary while unwinding the inner core. If the outer core begins to move towards the first mastic seal,
gently pull the outer core and jacketing tube towards the second mastic seal and continue unwinding the
inner core.
first rubber
mastic seal
2.6.3 Continue to install the cold shrink tube over the rubber mastic on the other cable by slowly pulling and
unwinding the outer core counterclockwise. This portion of the cold shrink tube installs differently than
typical cold shrink products in that as the tube shrinks, the end rolls under. The tube may need a slight
push to get over the second mastic seal.
completed splice
