7
78-8124-5866-5-E
3M
™
Cold Shrink QT-lll Silicone Rubber Three Core Inverted Skirted Termination
with High-K Stress Relief
3.8 Bind cable ground wire with four half-lapped layers of Scotch
®
Vinyl Electrical Tape Super 88 (wide vinyl tape)
(Figure 5). Limit width of tape wrapping to approximately 2-1/2" (63,5 mm).
Bottom View
Scotch
®
Vinyl Electrical Tape Super 88
(Wide Vinyl Tape)
2-1/2" (63,5 mm)
Figure 5
3.9 Loop cable ground wire back over armor (Figure 6). Adjust ground wire position over cable jacket to run
parallel with tail of ground braid assembly.
Note: Do not make sharp or tight bends in ground wire. Ground wire loop should not extend beyond edge of protective
jacket section as shown.
Do not extend wire loop beyond this edge
Rotated View of Cable
Figure 6
3.10 Apply two half-lapped layers of Scotch
®
Vinyl Electrical Tape Super 88 (wide vinyl tape) over looped ground
wire area (Figure 7).
Vinyl Tape
Scotch
®
Vinyl Electrical Tape Super 88
(Wide Vinyl Tape)
Figure 7
