11
5.0 INSPECTION
5.1 i-Safe™ RFID TAG:
The Self-Retracting Lanyard includes an i-Safe™ Radio Frequency Identification (RFID)
tag. The RFID tag can be used in conjunction with the i-Safe handheld reading device and web based portal
to simplify inspection and inventory control and provide records for your fall protection equipment. For
details, contact a Capital Safety Customer Service representative (see back cover); or if you have already
registered, go to
http:
//isafe3.capitalsafety.com/Pro/
. Follow the instructions provided with your i-Safe
handheld reader, or on the web portal, to transfer your data to your web log.
5.2 INSPECTION FREQUENCY:
The Sealed-Blok Self-Retracting Lanyard must be inspected at the intervals
defined in Section 2.2 -
Inspection Frequency”. Inspection procedures are described in the “Inspection and
Maintenance Log” (Table 2).
IMPORTANT:
If the Self‑Retracting Lanyard has been subjected to fall arrest or impact forces it must be immediately
removed from service, marked as “UNUSABLE”, and inspected by a Competent Person per instructions in Table 2 to
determine service options.
IMPORTANT:
Extreme working conditions (harsh environments, prolonged use, etc.) may require increasing the
frequency of inspections.
5.3 UNSAFE OR DEFECTIVE CONDITIONS:
If inspection reveals an unsafe defective condition, remove the
Self-Retracting Lanyard from service immediately, mark as “UNUSABLE”, and perform a Competent Person
inspection to determine service options.
NOTE:
Only Capital Safety or parties authorized in writing may make repairs to this equipment.
5.4 PRODUCT LIFE:
The functional life of DBI-SALA Self-Retracting Lanyards is determined by work conditions
and maintenance. As long as the product passes inspection criteria, it may remain in service.
6.0 CLEANING, SERVICE, STORAGE, AND TRANSPORT
6.1 CLEANING:
Cleaning procedures for the Self-Retracting Lanyard are as follows:
•
Periodically clean the exterior of the SRL using water and a mild soap solution. Position the SRL so
excess water can drain out. Clean labels as required.
•
Clean lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with
heat. An excessive buildup of dirt, paint, etc. may prevent the lifeline from fully retracting back into the
housing causing a potential free fall hazard. Replace lifeline if excessive buildup is present.
6.2 STORAGE AND TRANSPORT:
Store and transport Self-Retracting Lanyard in a cool, dry, clean environment
out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the SRL after any
period of extended storage.
Summary of Contents for DBI SALA Sealed-Blok 3400828
