9
Introduction
3M™ Digital WallDisplay
© 3M 2004. All Rights Reserved.
E
N
G
L
IS
H
WARNING
To reduce the risk of environmental contamination due to lead based solder:
• Don’t throw circuit boards in the trash. Dispose of circuit boards in accordance with your respective
governmental agencies for hazardous waste.
To reduce the risk associated with radio interference:
• This is a Class A product. In a domestic environment, this product may cause radio interference in which case
the user may be required to take adequate measures.
To reduce the risks associated with hazards related to the use of alcohol based cleaners;
• Follow all instructions and recommendations in the Sanford Expo Whiteboard Cleaner Material Safety Data
Sheet and product label.
CAUTION
To reduce the risk associated with tripping over cables:
• Position the product’s power cord and data cable so that they will not be tripped over.
To reduce the risk associated with chemical leakage, hot battery surface, and battery rupture:
• Use only same type AAA alkaline batteries in remote control.
• Use only same type AA alkaline batteries in presentation pen.
• Use only same type CR2032 Lithium coin batteries in pens and eraser.
• Avoid fire and heat sources above 100° C.
• Do not short circuit batteries.
• Do not attempt to recharge batteries.
• Do not break or disassemble batteries.
• Avoid eye and skin contact, ingestion and inhalation of battery chemicals in the event of a ruptured or broken
battery.
• Replace all batteries at the same time.
• Properly orient the plus (+) and minus (-) terminals of the batteries.
• Remove batteries when not used for an extended period of time.
To reduce the risks associated with impact from the projection arm and tripping over the legs of the
portable cart:
• Do not use this Wall Display around unsupervised children.
• Do not allow children to hang onto the projection arm.
