78-9237-1692-8
5
!
WARNING
This WARNING applies to the use of the Direct Connect Cables and the
Transmitter.
To avoid potential shock, or electrically damaging the Transmitter, when
setting up the Transmitter to locate using the Direct Connect method,
follow these basic steps
;
• ALWAYS plug the Direct Connect Cable into the Transmitter Output Jack
[T-6] BEFORE connecting the leads to the cable/pipe to be located and the
ground rod.
– Connect the red lead to the cable/pipe.
– Connect the black lead to ground rod.
A POTENTIAL FOR ELECTRICAL SHOCK, AND/OR TRANSMITTER
ELECTRICAL DAMAGE, EXISTS WHEN USING THE DIRECT CONNECT
CABLE ON CABLES ENERGIZED WITH ELECTRICAL POWER IF THE ABOVE
INSTRUCTIONS ARE NOT FOLLOWED.
USE APPROPRIATE SAFETY PROCEDURES.
CHECK VOLTAGE BEFORE CONNECTING TRANSMITTER. VOLTAGE
HIGHER THAN 240 VOLTS WILL DAMAGE EQUIPMENT. FOLLOW
STANDARD PROCEDURES FOR REDUCING THE VOLTAGE.
About This Manual
The 2250M-iD Contract locator is designed to provide contract locators a tool
to locate cables, pipes and EMS markers. The iD option provides locating and
read capability to 3M
TM
iD Markers.
In order to demonstrate all available functions, the illustrations depict the
2250M-iD Contract Locator receiver unit and the 2250 3-watt transmitter.
