9
78-8140-3820-0-B
7.5
Assemble the clamp shell(s) onto the bottom
half of the cable housing. Note the orientation
of the pin and socket and assemble accordingly.
Note: Different-sized cables may require different-
sized clamps. Ensure that the correct clamp
set matches the cable when assembling in the
bottom housing and the cable clamp.
8.0 Cable Seal Installation
8.1
First clean the cable sheath thoroughly using an
alcohol wipe. Make sure the cable sheath is free
of any grease or dirt.
Note: Carefully follow health, safety and environmental
instructions as given on the Material Safety Data
Sheet for the alcohol wipe.
Scuff the first 3" of each cable sheath using
supplied sheath scuff. Ensure the cable is
completely scuffed around the perimeter of the
cable.
Hint: Scuffing is easier if you tear the sheath scuff in
narrow strips along the length of the strip.
Washer Selection
8.2
Locate and remove two washers on parts trees for each cable (four washers total). Note that washer
sizes are labeled on the washer as shown below. Note that inches are on one side of the washer and
millimeters are on the other side.
Note: See chart in section 6.2 for required washer.
