9
78-8140-2401-0-B
7.5
Assemble clamp shell(s) onto bottom half of
cable housing. Note the orientation of pin and
socket and assemble accordingly.
Note: Differently-sized cables may require differently-
sized clamps. Ensure that the correct clamp sets
matches the cable when assembling in bottom
housing and cable clamp.
8.0 Cable Seal Installation
8.1
First thoroughly clean the cable sheath using an
alcohol wipe. Make sure cable sheath is free of
any grease or dirt.
Note: Carefully follow health, safety and environmental
instructions as given on Material Safety Data
Sheet for the alcohol wipe.
Scuff the first 3" of each cable sheath using
the supplied sheath scuff. Ensure the cable is
completely scuffed around the perimeter of the
cable.
Hint: Scuffing is easier if you tear the sheath scuff in
narrow strips along the length of the strip.
Washer Selection
8.2
Locate and remove two washers on parts trees for each cable (four washers total). Note that washer
sizes are on washer as shown. Note that inches are on one side of the washer and millimeters are on the
other side.
Note: See chart in section 6.2 for required washer.
