Travel Document Reader User Guide
DT-01715C
© 3M 2006 All rights reserved.
14
Testing Reading and Communication
This test determines if the reader is functioning properly.
1.
Start the test application
SalesDemo.exe
from the shortcut created during software
installation.
2.
Verify that the green LED (READY) is on and the test application indicates
Ready to
Scan
. (The reader is ready to accept documents).
3.
Select the test card AW-00276 “Full Page Reader Test Card”.
Figure 19: Test Card
4.
Place the test card face down on the document window, aligned with the left guide, with
the test card instructions facing up.
Figure 20: Test Card Placement
5.
Push the card to the back of the document window until it stops.
Note:
Do not move the document during the scanning process.
6.
Observe the LEDs during the scanning procedure.
•
The READY LED turns off and the amber LED (BUSY) turns on.
•
The amber LED (BUSY) remains on while the reader scans and processes the data.
•
The green LED (OK) turns on, indicating a successful read.
Summary of Contents for Full Page Reader
Page 8: ......
