1. Disconnect and Remove the XT-1 Basestation off the wall
To remove the base station cover:
Disconnect power from the base station.
Loosen the two screws located at the bottom of the cover.
Lift the cover upward and away. The display and keypad remain with the base, not with the cover.
Disconnect wires terminating on XT-1 basestation
Disconnect one wires, one at a time, from the phoenix connectors on the XT-1 basestation.
- Make sure you label each wire so you know what terminal they connect to.
For example: MEN SKR +, or MEN SKR -, or GND or MIC+ or MIC- etc
This should not be required if you have employed 3Ms guidelines on properly terminating color coded cables to
terminals on the XT-1 Basestation.
Blue & White -> Order Point Speaker
Red & Black +Shield -> Order Point Micr GND
Green & Yellow -> Loop terminals on Vehicle Detector board (If using Internal Vehicle Detector)
Disconnect any Range Extenders
Disconnect one any Omni-Directional or Patch antennas connected to the XT-1 Basestation
Disconnect any external Momentary Closed Switches they may have installed to change Order Taking Modes,
SPLIT/CROSS, or DAY/NIGHT
Most often these external switches are labeled (on the wall). It is important that while re-wiring, the same functionality (relative
Most often these external switches are labeled (on the wall). It is important that while re-wiring, the same functionality (relative
to each switch) is maintained.
Remove the XT-1 basestation off the wall
Detach the XT-1 basestation off the wall by removing the 4 screws.
Set XT-1 basestation aside.
Screws
Screws
3
