International - ENG
February 2021
3M-Matic
™
8000a-I / 8000a3-I - Type 11700
Page 20
44-0009-2161-7 / ECO# 0078483
7.7 Completion of Taping Heads
See Manual 2 or 3 for Complete
Instructions:
1. Place the Upper Taping Head in
a convenient working position.
2. Use
Figure 7-8
and tape threading
label. Position the tape supply roll
so the adhesive side of tape is
facing the front of the taping head
as it is pulled from the supply roll.
3. Attach the threading needle to
the end of the roll. Guide the
threading needle around the
wrap roller
(Position 1)
then
back around the one-way
tension roller
(Position 2).
4. Continue pulling the threading
needle down and guide it
between the two (2) rollers on
the apply arm
(Position 3).
5. Pull the threading needle down
until the tape travels between the
apply plate and the ears of the
apply arm
(Position 4)
until it
extends past the applying roller.
When properly threaded the
adhesive side of the tape should
be facing the knurled rollers at
position 2 and also position 3.
6. Cut away any excess tape and re-
peat steps for Lower Taping Head.
Important –
Do not cut against the
apply roller - roller
damage could occur.
7.8 Outboard Tape Roll Holder
If you intend to use the outboard
tape roll holder, proceed as follows:
1. Remove the lower taping head
from the machine.
2. Remove the tape drum bracket
assembly, stud spacer, and fast-
eners from the lower taping head.
3. Install alternative wrap roller and
bracket on the head in place of
tape bracket. Replace lower
head into machine.
4. Install and secure tape drum
bracket assembly on the entry
end of the lower frame
(as shown in
Figure 7-9).
7.9 Preliminary Electric Inspection
Before connecting the machine to the mains
please carry out the following operations:
7.9.1
Make sure that the socket is provided with
an earth protection circuit and that both the
mains voltage and the frequency match
the specifications on the name plate.
7.9.2
Check that connection of machine to the
mains meets safety regulations in your country.
7.9.3
The machine is fitted with a main switch and a
circuit breaker. The user should check that the
electrical settings of machine are compatible
with all the components of the mains system.
7.10 Machine Connection to the Mains
This machine may be recieved without an
electrical plug. Select a plug suitable for your
existing electrical service and compliant with
local electrial codes. Connect the Line, Neutral,
and Ground (Protective Earth) wires of the
machine to the appropriate terminals of the
plug following plug manufacturers instructions
(400V, 3Ph motors are in a delta configuration).
Important:
All connections must be made by a
quailfied electrical service technician.
One Way
Tension
Roller
Tension
Wrap
Roller
Knurled
Roller
Wrap
Roller
Applying
Roller
Threading
Needle
#1
#2
#3
#4
Figure 7-8
Figure 7-9
7. Installation
(continued)
