Vers. (11/02)
Pentamix
TM
2
16
Pentamix
TM
2
5.14 Chains
NOTE
It is recommended that the chains are only replaced in pairs as both chains have
been mechanically adjusted as a pair by the factory. This firstly ensures that the
traverse does not tilt when moved and secondly, prevents excessive wear to the
feed motor gears.
Changing chains
1. Remove plunger discs - see section 5.2
2. Remove case base - see section 5.3
3. Remove both side covers - see section 5.4
4. Remove case bottom section - see section 5.5
5. Remove mixer shaft - see section 5.6
6. Remove case top section - see section 5.7
7. Remove clutch - see section 5.10
8. Move traverse to reveal the recessed-head screws fixing the chains to traverse in
the bore
9. Remove traverse screws fixing cross-member to chain
10. Remove left side - see section 5.11
11. Remove drive shaft - see section 5.13
12. Remove connection to bearing plate for mixer motor
13. Remove both chains
14. Install new chains in reverse order
NOTE
When installing the two chains always check for identical number of links.
15. Check shut-off point - see section 5.19
16. Assembling housing - see section 5.20
17. Functional test - see section 6
Summary of Contents for Pentamix 2
