© 3M 2020. 3M and PPS are trademarks of 3M Company, used under license in Canada. 60-4551-0863-3, 34-8725-5925-6
3M™ Performance Spray Gun HVLP – Gravity
Maximum Operating Pressure: 20 psi | 1.38 bar
Adding the 3M
™
PPS
™
Series 2.0 Spray Cup
System Components
Insert the 3M™ PPS™ Series 2.0 Spray Cup System
disposable liner into the 3M™ PPS™ Series 2.0 Spray
Cup System mixing cup.
1
2
Pour material to be sprayed into the 3M™ PPS™
Series 2.0 Spray Cup System mixing cup. Stir
as needed.
4
Turn until tight. Insert 3M™ PPS™ Series 2.0
Spray Cup System sealing plug prior to shaking
or sealing.
5
Attach spray gun to filled 3M™ PPS™ Series 2.0
Spray Cup System cup.
3
Place the 3M™ PPS™ Series 2.0 Spray Cup
System lid with built-in filter on top of the
3M™ PPS™ mixing cup with liner and snap
into place.
For additional questions, contact your local 3M representative
or:
1 877 MMM CARS (666-2277)
See manual for additional use and safety information.
Cleaning
Once coating application is complete, disconnect the air hose from the gun.
1
2
To drain back paint into cup - Invert cup, pull trigger, and tap the PPS™ cup on
a table 3 times.
4
Store spray gun with a nozzle attached to protect the needle.
3
Rinse out nozzle spout and flush cleaning solvent through the nozzle by
pulling trigger with fluid tip pointed straight down into receptacle to collect
waste solvent.
