It is important that you drill your SafeLok hole to the
manufacturer’s required diameter. All holes must be
drilled to a 3/4” diameter. Do not use holes larger than
3/4” or holes that are not round in shape.
NEVER USE A BENT DRILL BIT
Drill a 3/4” diameter hole .
Drill center of hole at least 1-1/2” from any edge or corner.
Always inspect a previously drilled hole, make sure the hole is round and a
true 3/4” diameter hole.
Inspect the unit for damage each time you use it. If damage has occurred,
dispose of unit.
Make sure the Toggle Bar is activated in the open position.
The Hole Plug must be seated in the steel hole.
Never rely on a unit placed by unauthorized personnel.
Never leave a unit inserted in a hole overnight.
8
Use For Fall Protection Only
SEE DIAGRAMS ON NEXT PAGE
INSTRUCTIONS FOR USE IN STEEL
This product is to be used by trained fall protection personnel
only. It is to be anchored in accordance with manufacturer’s
requirements.
The steel flange must be at least 1/4” thick and you must drill the
center of the hole at least 1-1/2” from any edge or corner.
