3M ScaleGard HP, Installation And Operation Instructions Manual

8

Wall Mounting the ScaleGard

TM

HP Base Unit 

(Mounting Template included with unit)

1.  Draw a level line on the wall where the bracket is to be mounted. Hold bracket key holes on level line and mark locations for screws. 

2.  Install mounting screws (not included) into each of the initial key holes as shown in fi gure 2. Be sure to leave 1/8” to 1/4” (0.3 to 0.6 cm) space 

between the bottom of the screw head and the wall so that the bracket can be hung. (assume system weight of 57 lbs. (25.9 kg)) 

NOTICE

To reduce the risk associated with property damage due to water leakage or fl ooding:
 • 

Mount ScaleGard

TM

 HP base unit in such position as to prevent it from being struck by other items being used in the area 

  of installation. Ensure that the location and fasteners will support the weight of the system when installed.  

IMPORTANT NOTES

 • 

Allow a minimum of 3” (7.62 cm) clear space under fi lter to facilitate cartridge change.

3.  Hang manifold from the mounting screws. 

4.  Once the bracket is hung, tighten the mounting screws so that the bracket is snug between the screw and the wall.

5.  Install remaining mounting screws in locations as shown in fi gure 2. 

MOUNTING HOLES

MOUNTING HOLES

MOUNTING HOLES

Figure 2 — Installing Mounting Screws

Operational weight - 57 lbs.