80-6111-841-1
Safety Statements and Symbols (continued)
m
WARNING
To reduce the risks associated with chemical exposure:
Read and understand all safety information contained in each applicable material MSDS and on the label on each dual
material cartridge inserted into the applicator system prior to use;
This applicator equipment is only to be used by trained professionals who are familiar with its possible hazards;
Do not point the applicator at anyone or at any part of your body;
Always wear appropriate Personal Protective Equipment including eye, respiratory, and skin protection as required
for each application. Select and use personal protective equipment based on exposure assesment of the specific
application situation.
To reduce the risks associated with fire and explosion:
Use applicator only in well ventilated area to control vapor concentrations;
Keep cartridge materials and applicator system away from fire;
Check and follow all applicable national, state and local codes regarding safety, fire codes and air exhaust for each
application;
Use only 3M approved dual component cartridge materials in the applicator system
•
•
•
•
•
•
•
•
m
CAUTION
To reduce the risks associated with air pressure:
Ensure air line input < 145psi and that applicator system regulators are properly adjusted prior to each use;
Do not alter or modify the applicator system and use only 3M approved service parts;
Check the applicator system air pressure regulators, all hoses, mixing tubes, connections and all other air pressurized
components for secure attachment and damage daily and replace all worn or damaged parts prior to use;
Ensure line air supply is adequately conditioned for the applicator system and the application;
Follow required air pressure relief procedures for relieving air pressure from the unit
To reduce the risks associated with impact:
Handle and operate the applicator system with both hands to prevent dropping the unit;
Route supply line air hose away from traffic areas, sharp edges, moving parts and hot surfaces to prevent tripping and
component failure
To reduce the risks associated with environmental contamination:
Dispose of used material cartridges, mixing tubes and nozzles per federal, state and local regulations
•
•
•
•
•
•
•
•
