11
Operator’s Guide
3M
™
Super Close Projection System SCP725
© 3M 2011. All Rights Reserved.
E
N
G
L
IS
H
m
CAUTION
To reduce the risk associated with eye strain, nausea, dizziness, headache:
•
Take a break every hour for 15 minutes.
•
Do not view 3D images or 3D full motion videos while standing or walking.
•
Only use 3D Active Glasses for viewing field sequential 3D projected images.
•
View 3D image from at least 2 m (7 feet) or greater distance.
•
Make sure the right-eye and left-eye images are properly synchronized using the 3D menu of the
projector.
To reduce the risk associated with falling:
•
Do not view 3D images or 3D full motion videos while standing or walking.
•
Do not allow anyone with a history of photosensitive diseases like epilepsy to wear 3D glasses or
view field-sequential 3D projected images.
•
Do not wear 3D Active Glasses while walking or standing.
To reduce the risk associated with intense visible light:
•
Avoid looking directly into the projector lens while the lamp is on.
To reduce the risk associated with impact of a falling projector:
•
Use only the 3M brand wall/ceiling mounting hardware kit if wall or ceiling mounting is desired.
•
Installation of the 3M brand wall/ceiling kit must only be performed by qualified personnel.
•
Adhere strictly to the proper installation procedure as outlined in the installation instructions when
installing the 3M wall/ceiling kit.
•
When not mounted, always operate the unit on a flat and sturdy surface.
To reduce the risk associated with explosion, and/or chemicals from leaking battery:
•
Use only with battery type AAA.
•
Orient the battery’s plus (+) and minus (-) terminals according to the markings found on the remote
control.
•
Do not leave the battery in the remote for an extended period of time.
•
Do not heat, disassemble, short, recharge, or expose the batteries to fire or high temperature.
•
Do not carry batteries loose in your pocket or purse.
•
Avoid eye and skin contact in the event that battery would leak.
•
Do not mix used and new batteries.
To reduce the risk associated with tripping, and/or impact:
•
Position the power cord and cables so that they can not be tripped over.
To reduce the risk associated with environmental contamination:
•
Dispose of mercury lamp, exhausted batteries, and other electronic components in accordance with
applicable federal, state and local regulations.
To reduce the risk associated with lamp rupture related hazards:
•
In event of lamp rupture, call 3M authorized service provider for repair. Ruptured lamp repair is
not user serviceable.
•
Wash your hands thoroughly if contact with ruptured lamp debris has taken place.
•
Ventilate the area where the lamp rupture occurs. The lamp operates at high temperature.
To reduce the risk associated with hot surface of lamp cartridge:
•
Before replacing the lamp, allow the lamp to cool for 60 minutes and then unplug the projector
from the electrical outlet.
To reduce the risk associated with environmental contamination due to mercury:
•
Hg: Lamp contains mercury. Don’t throw in trash. Dispose according to local, state, or federal
laws. See www.lamprecycle.org or call 1-800-328-1371.
SAVE THESE INSTRUCTIONS
Summary of Contents for SCP725
Page 2: ......
