18
4.17 Rotate open the polishing face of the polishing puck
assembly to expose the ends of the fibers. Use a cotton
swab moistened with isopropyl alcohol to clean the fibers.
Clean both fibers by running the applicator along the
length of the two exposed fibers, toward the fiber ends.
Stroke past the ends of the fiber in an outward motion to
make sure the entire shaft of fiber has been cleaned.
Tech Tip: Two strokes of the applicator on each side of the
fiber should be adequate.
Note: Carefully follow safety, health and environmental
information on container label or Material Safety Data
Sheet for isopropyl alcohol being used.