Note before mounting:
Don't place or install the device in area near water or
moist, keep the relative humidity of the device
surrounding between 5%~95% without condensation.
Before power on, first confirm the supported power
supply specification to avoid over-voltage damaging the
device.
The device surface temperature is high after running;
please don't directly contact to avoid scalding.
【
DIN-Rail Mounting
】
The product adopts 35mm standard DIN-Rail mounting which
is suitable for most industrial scenes, mounting steps as
follows:
Step 1
Check if the DIN-Rail mounting kit is installed firmly.
Step 2
Insert the bottom of DIN-Rail mounting kit (one side
with spring support) into DIN-Rail, and then insert
the top into DIN-Rail.
Tips:
Insert a little to the bottom, lift upward and then insert
to the top.
Step 3
Check and confirm the products is firmly installed
on DIN-Rail, then mounting ends.
【
Disassembling DIN-Rail
】
Step 1
Device power off.
Step 2
After lift the device upward slightly, first shift out the
top of DIN-Rail mounting kit, and then shift out the
bottom of DIN-Rail, disassembling ends.
Note before powering on:
Power ON operation: First insert the power supply
terminal block into the device power supply interface,
and then plug the power supply plug contact and power
on.
Power OFF operation: First, remove the power plug,
and then remove the wiring section of terminal block.
Please pay attention to the above operation sequence.
【
Power Supply Connection
】
DC power supply
The device provides 3-pin power supply input terminal blocks
and supports 1 DC power supply system which has
non-polarity and anti-reverse connection function, that the
device can work normally after reverse connection. Voltage
range: 12~48VDC.
AC power supply
The device provides 3-pin power supply input terminal blocks,
and supports 1 AC power supply. Power supply range:
100~240VAC/DC.
【
DIP Switch Settings
】
Provide 4 pins DIP switch for function settings, where "ON" is
enable valid terminal. DIP switches definition as follows:
DIP
Definition
Operation
1
Flow
control
Set the DIP to ON, copper port
supports IEEE802.1x flow control,
fiber port supports back pressure
flow control.
2
Specified
10M
Set the DIP to ON, copper port rate
would be forced to be in 10M full
duplex mode.
3
Reserved
―
4
Reserved
―
【
Checking LED Indicator
】
The device provides LED indicators to monitor the device
working
status
with
a
comprehensive
simplified
troubleshooting; the function of each LED is described in the
table as below:
LED
Indicate
Description
PWR
ON
PWR2 is connected and running
normally
OFF
PWR2
is
disconnected
and
running abnormally
Link/Act
(1-5)
ON
The
Ethernet
interface
has
established
an active network
connection.
Blinking
The Ethernet interface is in a
network activity state.
OFF
Ethernet port has not established
valid network connection
【
Specification
】
Panel
100M fiber port
100Base-FX,
optional
SC/ST/FC
100M copper port
10/100
Base-T(X)
self-adapting RJ45 port, full
duplex
or
half
duplex
self-adapting,
support
MDI/MDI-X self-adapting
Indicator
Power
supply
indicator,
interface indicator
Switch Property
Backplane bandwidth
1.6G
Packet buffer size
1Mbit
MAC Address Table
2K
Power supply
Model
I,
Model
II,
Model III
Support non-polar connection
Model IV,
Model V,
Model VI
100~240VAC/DC
Access terminal block
4 pins 7.62mm pitch terminal
blocks
Power consumption
