User manual
13
5.5 Port configuration
5.5.1 Port settings
The port configuration interface mainly include port type (Electric port or optical port), setup speed mode and
duplex mode, flow control. Only when the port is enabled for the port speed, duplex, flow control will work.
Select auto-negotiation, speed, and duplex auto-negotiation.
Configuration Items
Description
Port
Port name, corresponding to mark in panel.
Type
Display port type (TX or FX).
Speed
Display configurable speed of port or auto-negotiation mode.
Duplex
Auto-negotiation
（
AUTO
）
,full duplex
（
FULL
）
, half duplex
（
HALF
）
optional, default
mode is auto-negotiation mode.
Enable
Configurable port enables or disable. Selecting square frame is for enable the
corresponding port. It can not transmit data if any port disable. The default is ―Enable‖.
Flow Control
Whether selecting flow control to the port. Only can selecting flow control when the
port enable. The default is off.
Port setting interface, as shown in Figure 5.5.1
（
Figure 5.5.1
）
This feature is consistent with the port status of the port information, for example: set port 1 and port 2 is
for the hundreds of megabytes rate half double work, use network cable connect port 1 and port 2, by port
information for a query, you can view the status of port 1 and port 2, as shown in Figure 5.5.2. Port settings and
restarts the device when you are finished. View port information column of the port State, rate, whether or not
in accordance with reality.
