Powered by
www.3sense.tech
Nov. 2018
This device is part of 3Sense product family
Parameters' configuration protected by password.
7 days recording data
24 hours of battery autonomy
2. Mounting Guidelines
To properly mount the system, please consider the instructions and suggestions given in the
following chapters. Plan all wiring before installing your Pro-E 4.0. Also consider the cabinet space,
enclosure dimensions and rated environmental conditions. Use good wiring practices to minimize
problems that may occur due to electrical interference.
NOTE: Prevent metal fragments and pieces of wire from dropping inside the enclosure
of any Pro-E Main Unit. If necessary, place a cover over the components during
installation and wiring. Ingress of such fragments and chips may cause a fire hazard,
damage or malfunction of the device.
Every device is already programmed before delivery with all its functionalities, so it’s ready to
mount.
2.1. Environmental Considerations
Device’s main unit is restricted for indoor use, since its case is offered with IP40 protection.
However, external sensors can use IP67 protected probes, to allow their contact with fluids, dust
or UV radiation.
Ambient Temperature: 50°F (20°C) to 113°F (45°C)
Relative Humidity (RH): 60±25 %
NOTE: Locate Pro-E 4.0 away from AC power/motor wiring and sources of direct heat output
such as transformers, heaters, large capacity resistors, or shock and vibration sources. Avoid
using the device in areas where chemicals or flammable gases are present to minimize any
risk of ignition.
