3
1.2 Connecting
Connect your scanner to the PC using the USB cable. The flat end of the cable is plugged into the computer, the square
end into the scanner. The USB cable should be plugged into one of the rear ports of the computer.
Rear of the Legato2:
1.
Fan
2.
Power switch
3.
USB port
4.
Power supply port
Connect the power supply to the scanner power supply port and plug the power supply to the power outlet. Use
standard precaution when operating the scanner power supply.
Note!
It is important to remove the foam swing arm protector from inside scanner prior to powering on,
as this may result in damaging the scanner.
1.3 Starting
The 3Shape ScanServer application works as a software driver to bridge the gap between the scanner
hardware and the scanning application, ScanIt™. Its function is to provide low-level hardware communication
with the scanner to create a 3D pointcloud based on the scanner cameras input. Whenever a scan is to be
performed, the ScanServer needs to be "ON" and ready for operation.
With the launch of ScanServer, an icon with a flashing green light appears in the system tray. When this green light
becomes steady, the ScanServer is ready for operation. This manual does not cover the detailed functioning of
ScanServer since it is designed to operate unassisted in the background.
Launch the ScanServer application only after having plugged the scanner to the scan-server PC and switching the
scanner "ON"; otherwise, the following error message will pop up:
"No scanner is connected to the PC by USB. Please
check the power and USB cable and try again".
On starting ScanServer the first time, it will report that your scanner requires a calibration.
Note!
If the scanner is supplied with a supplied 3Shape PC, the default Windows user name and
password for the 3Shape PC is "
scan
".
Summary of Contents for Legato2
Page 1: ...3Shape Legato2 User Manual...