43
Antenna WASP Status Tab
Once you have connected to a Data Collector, as described in the section titled
Connecting to a Data Collector on page 36, you can view the status of a specific
antenna WASP sensor by following these steps:
1. Click on
the icon for the WASP sensor in the left pane.
2. Click on
the ‘Status’ tab in the right pane.
The status for the WASP sensor will appear in the right pane similar to the following:
Please refer to the section titled WASP Telemetry and Sensor Measurements on page
10 for a description of each field in the
‘Measurements’ and ‘Wireless Signal Strength’
sections.
The ‘Antenna WASP Information’ section lists additional information specific to the
sensor:
MAC Address
- displays the unique MAC address of the sensor on the wireless
network.
Firmware Version
– displays the version of the firmware running on the WASP
sensor.
Mode
– displays the current mode of the WASP sensor. The possible values are
o
Configuration
– This mode is usually only entered when the sensors are
first powered on. They report sensor information every minute for a
duration of 8 hours, in order to speed up the installation and configuration
process.
Summary of Contents for Antenna W.A.S.P.
Page 1: ...Antenna W A S P User s Guide...
Page 5: ...5 CE Mark Conformity...
Page 59: ...59 Technical Support Contacts...
