Cessna 182 Instruction Manual
33
Adjust the height of A2 to align it evenly with the
connector, and then glue A2 in position
Clip the Metal Clevis onto the Steering Arm
Install the rudder and elevator Horns as position shown
on the plan. Make the pushrods from 1.0 mm. push rod
wire and balsa push rod stick as shown on the plan.
Mark one of them “rudder,” the other “elevator”.
Lay the pushrod on the fuselage. Determine the location
of the pushrod exit slots and mark them with a pen. Drill
a hole at the slot location. Then use a cutter to cut out
the slot.
Install the elevator and rudder pushrods by inserting
them through the opening and out the pushrod exits.
Connect rudder and elevator pushrod to the horn
Route the servo wires through to the opening
Install the ailerons Horn as position shown on the plan
