17
Pre- Instruction for program buttons
1.
Short click the
SET
button : When in standby, it will clear the error and,
alarm display, then return to a normal display.
2. Short click the
CODE
button :
• (In the Setting Status) Exit the current operation and return to the
standby interface.
• When in standby, press the code button, A dot will be indicated in the
corner, it now enters the code leaning mode.
Now click the button on the hand transmitter you want to assign, the dot
will disappear ,then press again the same button on the hand transmitter
and, the dot will flash, confirming the code learning is complete.
3. Short press the
UP
button: The door will open.
4. Short press the
DOWN
button: The door will close.
(When the door is opening or closing, it will stop if you press any key.)
5. Long press the
SET
button: Enter the function setting interface.
6. Long press the
CODE
button : Press and hold
CODE
button until a C is
indicated on the display. All stored remotes will be deleted.
7. Long press the
UP
button: Increase the resilience. (Keep press DOWN
button, after 4 seconds, it will scroll to display 0-1-2, choose the number
you want. 1=increase 25% 2=increase 50%)
8. Long press the
DOWN
button : Restore Factory Settings
Long press the
DOWN
button, after 4 seconds, it will scroll
to display,
then the garage door opener will revert to
factory default settings. .
All configuring , except for the transmitter code learning needs to be
done again.
PROGRAMMING INSTRUCTIONS
Summary of Contents for 4DS2 v1
Page 1: ...Installation instructions and user guide Sectional and Tilting door operator 4DS2 v1...
Page 2: ......
Page 4: ......
