24
7. REVERSAL HEIGHT SETTING
a. Press and hold the
SET
Button until “1” appears on the
display, next press the the
UP
button until “7” appears
on the display to enter this function setting then release
the button.
b. Press the
SET
button again. The unit is now in reversal
height adjustment mode. And then you will see a figure
“0” with flash dot appears on the display.
c. Press
UP / Down
button once to set the reversal height
while closing (0~9).
d. Press the
UP
button to increase , or the
DOWN
button
to decrease.
Figure “0” means the door will rebound to the open
limit position. Figure “1~9” means the door will rebound
to the position of the whole travel. One tenth to Nine
tenth of the whole travel etc...
e. Press the
SET
button to confirm the set and it will back
to standby status automatically and display “ll”.
NOTE
: The reversal height is set on “0” as standard in
factory.
PROGRAMMING INSTRUCTIONS
INCREASE HEIGHT
DECREASE HEIGHT
Summary of Contents for 4DS2 v1
Page 1: ...Installation instructions and user guide Sectional and Tilting door operator 4DS2 v1...
Page 2: ......
Page 4: ......
