1
2
3
10.1 Aircraft frequency matching: Turn on the power of the
aircraft and place it on a horizontal surface. At this
time, the aircraft placed on the horizontal surface will
automatically enter the frequency matching state, and
the front white light and the rear red light will flash.
10.2 Turn on the remote control (default mode): long press
the power switch button (step 1), turn on the power
and the indicator flashes; push the throttle lever up to
the top (step 2) and then to the bottom (step 3), and
thus the frequency matching is successful, the UAV
lights change from flashing to being permanently on.
Please choose an outdoor and open environment with no rain and snow and low wind. Please stay
away from crowds, trees, wires, tall buildings, airports, and signal transmission towers when flying. Do
not fly in a too small indoor environment with lots of things.
The aircraft/remote controller must ensure sufficient power or it cannot take off!
Note: Set the aircraft in a correct direction, and the nose
shall face forward. It must be placed on the horizontal
plane.
Warning
8. Remote control battery installation:
9. Environmental requirements before flight:
10. Preparation instructions before flight(using remote control):
Battery cover
AAA battery
Battery installation:
8.1 Remove the battery cover.
8.2 According to the polarity instructions on
the battery compartment, remove the
battery cover on the back and insert a
2X “AAA” battery (not included).
Instructions in charging:
● Do not put the charged battery in a place with high temperature
and heat, such as an open flame or an electric heating device,
otherwise damage or explosion may occur.
● Do not hit or beat the surface of hard objects with the battery.
● Do not disassemble the battery.
● Do not immerse the battery in water, and please store the battery
in a dry place. ● Do not leave battery alone when charging.
Warning
When not flying, please do not install
the battery in the aircraft to avoid
battery damage.
Note
1. The positive and negative poles and the positive and
negative poles of the battery box must be identified when
inserting the battery, and error is not allowed.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries.
05
