Quick Installation Guide
EAP717 Enterprise Access Point
ENGLISH
Copyright © 4IPNET, INC. All rights reserved.
11
Click on the
Wireless
button on the main menu.
Select the
Repeater
tab.
Choose
WDS
as the
Repeater Type
.
Choose the desired RF card and WDS profile:
(a) Enable
WDS
.
(b) Enter the
MAC Address
(peer AP) and then Click
SAVE
.
If you are using another EAP717 as the peer AP, simply repeat the above-mentioned steps to configure
another peer AP(s).
Note:
On each and every configuration page, you may click
SAVE
to save the changes of your configured
settings, but you must reboot the system for the changes to take effect. After clicking
SAVE
, the
following message will appear:
“Some modifications have been saved and will take effect after
Reboot.
”
Congratulations!
Now, 4ipnet EAP717 is installed and configured successfully.
After EAP717's network configuration is completed, please remember to change the IP Address of
your PC Connection Properties back to its original settings in order to ensure that your PC functions
properly in its real network environments.
It is strongly recommended to back up your configuration settings.
For further configuration and information, please refer to the User’s Manual.
P/N: V10020140917
