Quick Installation Guide
EAP750 Enterprise Access Point
ENGLISH
Copyright © 4IPNET, INC. All rights reserved.
3
Hardware Installation
Please follow the steps mentioned below to install the hardware of EAP750:
1. Place the EAP750 at the best location.
a) The best location for EAP750 is usually at the center of your intended wireless network.
b) If admin would like to mount the EAP750 on the wall (on a socket), the figure below indicates how the
mounting kit can be used on the back of the device. Screw the panel to the EAP750, and then turn the panel
clockwise to fasten it with the AP.
2. Connect the EAP750 to your network device.
Connect one end of the Ethernet cable to the Uplink port of EAP750 and the other end of the cable to a switch,
a router, or a hub. EAP750 is then connected to your existing wired LAN network.
There are two ways to supply power over to EAP750.
3. Connect the DC power adapter to the EAP750 power socket.
EAP750 Uplink port is capable of receiving DC currents. Connect an IEEE 802.3af-compliant PSE device (e.g.
a PoE-switch) to the Uplink port of EAP750 with the Ethernet cable.
Now, the Hardware Installation is complete. For more information on installing the wall and ceiling mount kit,
please refer to the Mounting Kit Installation Guide provided.
Using a different power adapter may damage this system.
To verify the wired connection between EAP750 and you switch / router / hub, please also
check the LED status indicator of the respective network devices.
