Product Handbook
Product Handbook
Product Handbook
Product Handbook
EAP760 Enterprise Access Point
ENGLISH
Copyright © 4IPNET, INC. All rights reserved.
7
Hardware Installation
Please follow the steps mentioned below to install the hardware of EAP760:
1. Place the EAP760 at the best location.
The best location for EAP760 is usually at the center of your intended wireless network.
2. Connect the EAP760 to your network device.
Connect one end of the Ethernet cable to the Uplink port of EAP760 and the other end of the cable to a switch,
a router, or a hub. EAP760 is then connected to your existing wired LAN network.
There are two ways to supply power over to EAP760.
3. Connect the DC power adapter to the EAP760 power socket.
EAP760 Uplink port is capable of receiving DC currents. Connect an IEEE 802.3at-compliant PSE device (e.g.
a PoE-switch) to the Uplink port of EAP760 with the Ethernet cable.
Now, the Hardware Installation is complete.
•
Using a different power adapter may damage this system.
•
To verify the wired connection between EAP760 and you switch / router / hub, please also
check the LED status indicator of the respective network devices.
