Quick Installation Guide
HSG326
Wireless Hotspot Gateway ENGLISH
Copyright © 4IPNET, INC. All rights reserved.
5
The 110 punch-down block may be connected with the following pin assignment:
Orange
Blue
White Orange
White Blue
Brown
Green
White Brown
White Green
The HSG326 is now connected to your existing wired LAN network.
2.
To supply power over to HSG326.
Connect the
DC power adapter
to the HSG326 power socket on the lower panel.
Please only use the power adapter supplied with the HSG326 package. Using a
different power adapter may damage this system.
3.
Connect HSG326 to your outbound network device.
Connect one end of the
Ethernet cable
to the Uplink port of HSG326 on the back panel.
Depending on the type of Internet service provided by your ISP, connect the other end of the
cable to the ATU-Router of an ADSL, a cable modem, a switch or a hub. The Uplink LED
indicator should be ON to indicate a proper connection.
4.
Connect HSG326 to your network device.
Connect one end of the
Ethernet cable
to the LAN1 port of HSG326 on the lower panel.
Connect the other end of the cable to a PC for configuring the system.
Note:
HSG326
has 1 + 4 service zones, the
Default Service Zone
is mapped to
LAN1 and LAN2 port (192.168.1.254).