Quick Installation Guide
OWL300 Outdoor Access Point
ENGLISH
Copyright © 4IPNET, INC. All rights reserved.
3
OWL300 Bottom
1
Wall Mounting Holes
For hanging OWL300.
2
Pole Mounting Gap
For mounting OWL300.
3
5G LED
5G Wi-Fi status. The 5G LED will blink when there is 5G traffic.
4
2.4G LED
2.4G Wi-Fi status. The 5G LED will blink when there is 2.4G traffic.
5
LAN (PSE) LED
LAN status. The LAN (PSE) LED will light up when there is traffic passing
through the LAN port.
6
LAN (PD) LED
LAN status. The LAN (PD) LED will light up when there is traffic passing
through the Uplink port.
7
Status LED
OWL300 status. The Status LED will start blinking when the restart/reset button
is pressed. For the first 5 seconds, the LED will blink slowly (restart), and after
5 seconds, the LED will start blinking quickly (reset).
8
Power LED
Power status. The Power LED will always on when OWL300 is power-on.
9
Ground Connector
For connecting to ground wire.
10
Uplink Port
Offers uplink connection. This port can be used to connect to a controller,
gateway, or directly to the Internet. 802.3at PoE is also supported.
11
LAN Port
The ports for connections with LAN side devices. It also support 802.3af PoE.
12
Restart / Reset
Press once to restart the system; hold for more than 5 seconds to reset the
system to factory default settings.
