152
User Manual ENGLISH
WHG-Series Wireless WLAN Controller
Copyright © 2017, 4ipnet, Inc. All rights reserved. All other trademarks mentioned are the property of their respective owners.
WHG711
1
WAN1/ WAN2
(SFP)
Two combo WAN ports (SFP) are connected to the external network, such as
the ADSL Router from your ISP (Internet Service Provider).
2
LAN7/ LAN8
(SFP)
Client machines connect to WHG Controller via these LAN ports (SFP).
3
LED Indicators
There are four LED indicators, WAN1, WAN2, LAN7, and LAN8, to indicate the
traffic status of the SFP ports.
4
Reset
Press and hold the Reset button for about 5 seconds and status of LED on front
panel will start to blink before restarting the system. Press and hold the Reset
button for more than 10 seconds and status of LED on the front panel will start
to speed up blinking before resetting the system to default configuration.
5
WAN1/ WAN2
Dual Gigabit WAN ports (10/100/1000 Base-T RJ-45) for uplink connections to
the external network, such as the ADSL Router from Internet Service Provider.
6
LAN1 ~ LAN6,
LAN9 ~ LAN12
Client machines connect to WHG Controller via these LAN ports (10/100/1000
Base-T RJ-45).
7
USB
Reserved for future use.
8
Console
The system can be configured via a serial console port. The administrator can
use a terminal emulation program such as Microsoft’s Hyper Terminal to login
to the configuration console interface to change admin password or monitor
system status, etc.
9
LED Indicators
There are two LED indicators, Power and Hard-disk, to indicate different status
of the system.
10 LCD Display
Allows network administrator to check important system settings such as
network interface, SZ configurations, etc. The navigations buttons from left to
right respectively are “Esc”, “Up”, “Down”, and “Enter”.