36
User Manual ENGLISH
WHG-Series Wireless WLAN Controller
Copyright © 2017, 4ipnet, Inc. All rights reserved. All other trademarks mentioned are the property of their respective owners.
to the POS printer and the 4ipnet Gateway/Controller.
SDS200W
PRT-100
PRT-200
Hotspot 1
Hotspot 2
Put the devices in place.
Attach a SDS200W to a power adaptor provided in the package.
Attach a POS printer to a power adaptor provided in the package and turn on the power switch situated
on the left side of the device.
Connect a POS printer to the Console port of SDS200W by a RS-232 cable provided within the POS printer
package.
Connect SDS200W to your 4ipnet Gateway/Controller via Ethernet port.
Note
: it is neccessary to connect the correct LAN port if your WLAN controller is operating in Port-based
mode.
To verify if the connection, press FUNC + ‘1’ + ENTER to see if SDS200W is attached to a correct gateway
and is able to get an IP address from it. Additionally, press ‘Number’ + ENTER to see if an account with a
certain billing plan can be printed out.
Managing SDS200W on the Web Management Interface
SDS200W is designed specifically to operate in conjunction with all 4ipnet Gateways/Controllers, including
both HSG and WHG series. If you are not using default settings, before connecting SDS200W to your
4ipnet Gateway/Controller, some configurations steps are required.
Go to the Web Management Interface (WMI) for SDS200W’s relevant configurations. The default values
are:
IP address: 192.168.1.10
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.254
Remember to set the TCP/IP settings of the computer you use with a static IP address that is under the
same subnet as SDS200W. For example: 192.168.1.20.