User’s Manual
WHG Controller / HSG Gateway
ENGLISH
263
Available Bandwidth on WAN Interface:
This section of the configuration page allows the
administrator to specify uplink and downlink limitations to be enforced on the servicing WAN
interface.
Function of WAN2:
The WAN2 connection can be activated for Load Balancing or WAN
Failover.
Address for Detecting Internet Connection:
This section of the configuration page enables
the administrator to specify external targets to check for uplink status. WAN Failover or WAN
Load Balancing may be selected to be enabled along with a customizable disconnection
message to the end user.
3) IPv6
Status:
Enable or Disable IPv6 support on the selected WAN interface.
Interface:
Select the external interface of the device that will be configured with an IPv6
Summary of Contents for WHG315
