4KDVB CV-F01-RX User Manual Download

Page: 3 / 4

CV-F01-RX User Manual

Parameter Setting

The CV-F01-RX is available in the setting of contrast, brightness and saturability through the

configuration tool. The setting steps are as follows:

Step 1:

Connect the CV-F01-RX to the control computer by using the DB9 pin RS232 female

cross serial line with the item.

Step 2:

Put the CD into the control computer and decompress the configuration tool folder

that burned in the CD and install the tool. (You can also ask the technical specialist for the

configuration tool folder.)

Step 3:

Double clicking the configuration tool

will enter into the

Communication Setting

interface. Select serial port and baud rate as shown in figure 3. After

that, click the

button.

Figure 3 Communication setting interface

Step 4:

Parameter setting interface will show up after click the

button in step 3. Details as

shown in figure 4.

You can set the corresponding value of brightness, saturation and contrast

according to the actual demand.

Summary of Contents for CV-F01-RX

Page 1: ...nectors Figure 1 CV F01 RX Fiber Optic Receiver I O Connectors 2 Connection introduction Figure 2 CV F01 RX Fiber Optic Receiver Connection Note Please connect one single mode optical fiber to the RX port in the fiber optic connector CVBS and line audio can be output at the same time ...

Page 4: ... Manual 4 Figure 4 Parameter setting interface Note In addition to setting the transmitter resolution you can also view the transmitter information If you need to check the Current state please click the Load button ...