7. Insert an AAA battery into the battery compartment. Add the battery cover (part J) and secure it with a screw.
8.
Assemble the turning wheel (part D), the front plate (part E) and the back plate (part C) as shown. Secure the plates together with two
screws.
9. Slot the turning wheel assembly onto the base.
10. Push the track connector (part G) onto the end of the track in the base.
11. Place the spiral track (part B) on the base as shown. Make sure that the flat section of the track slots into the supporting plate on the
turning wheel assembly.
12. Push the track lock (part I) into the centre of the spiral track.
1. Place the motor (part F) on the base (part A) with the wire side facing downwards. Make sure the red and black wires pass through the
holes in the base as shown.
2. Place the small gear (part M) in the base as shown.
3. Slot the large gear (part K) into the drive gear (part L).
4. Place the gear assembly in the base as shown.
5. Place the motor cover (part H) over the motor and gears and secure it with two screws (part P).
6. Push the red and black wires into the terminals as shown and secure them with two terminal caps (part O).
D. INSTRUCTIONS
A
E
1
2
3
4
5
6
11
12
7
8
9
10
H
B
C
K
I
J
L
O
P
M
G
F
D
A
E
1
2
3
4
5
6
11
12
7
8
9
10
H
B
C
K
I
J
L
O
P
M
G
F
D
