DRUMMER
ROBOT
QUESTION AND COMMENTS
We treasure you as a customer and your satisfaction with this product is important to us. In case you have any comments or questions, or you find any
parts of this kit missing or defective, please do not hesitate to contact our distributor in your country, whose address is printed on the package. You are
also welcome to contact our marketing support team at Email: infodesk@4M-IND.com, Fax (852) 25911566, Tel (852) 28936241, Web site: WWW.4M-
IND.COM
A. SAFETY MESSAGES
1. Adult supervision and assistance are required at all times. 2. This kit is intended for children 5 years or older. 3. This kit and its finished
product contain small parts which may cause choking if misused. Keep away from children under 3 years old. 4. To prevent possible
short circuits, never touch the contacts inside the battery case with any metal.
5. Only
install battery after the kit is assembled. Adult
supervision is required. 6. Do not insert any
objects
into the cylinder wheel.
7. Please
read through
all
the instructions and keep them
since it contains important information.
B. USE OF BATTERIES:
1.
Requires
two
1.5V
AAA
batteries
(not included). 2. For
best
results, always
use
fresh
batteries.
3. Make
sure you insert
the
batteries
with the
correct polarities.
4.
Remove
the
batteries from
the kit when
not in use. 5. Replace
exhausted
batteries
straight away
to
avoid
possible
damage
to
the kit. 6.
Rechargeable batteries must be
removed
from the
kit
before recharging. 7. Rechargeable batteries
should
be
recharged under adult
supervision.
8. Make
sure that the supply terminals in the battery case are not short
circuited. 9. Do
not attempt
to recharge
non-rechargeable
batteries. 10.
Do
not
mix old and new
batteries. 11.
Do
not
mix alkaline, standard
(carbon-zinc), or
rechargeable batteries.
C. CONTENTS:
41-03442/1 20201020
Your Robot Drummer can play its beat on surfaces made from many different materials. Each different material will make the Robot
Drummer’s beat sound unique. Fix the Drummer to the material with adhesive tape to make a permanent beatbox. Here are some ideas
to get you started:
1. Put the Robot Drummer on its own box.
2. Put the Robot Drummer on a wooden table.
3. Put the Robot Drummer on a plate.
4. Put the Robot Drummer inside a metal sink.
F. TROUBLESHOOTING:
If the cylinder does not rotate:
• Check that you are using fresh batteries.
• Check that the batteries are inserted the correct way in the battery compartment.
• Check that the wires are correctly connected (Step D5) and are touching the metal terminal.
• Check that the pegs are blocking the rotation of the cylinder.
G. FUN FACTS:
• There is a band from the UK that uses a giant homemade drum kit and junk to perform percussion. They have been performing
worldwide since 2002!
• Drums are the world's oldest instruments, with their basic design remaining the same for a very long time.
• An American named Christopher Anthony played a drum roll for 8 hours, 1 min, 17 seconds at a shopping centre in California, USA, in
2012.
• In the past many machines were controlled in similar way to the Robot Drummer. They used drums with patterns of pins on them or
paper sheets or cards with patterns of holes punched in them.
• More than two hundred years ago, Jacquard looms that wove patterns in cloth were programmed by cards with holes punched in them.
Changing the pattern of holes in the cards changed the pattern in the finished cloth.
• Pianolas were automatic pianos that played tunes that were programmed by a roll of punched paper. Changing the pattern of holes in
the paper made a pianola play a different tune.
• In a music box pins on a turning drum play a tune by plucking small metal teeth that play notes.
• In the nineteenth century mathematician Charles Babbage built a mechanical computer that was programmed to do different
calculations by punched cards.
• Early electronic computers were not programmed on screen as modern computers were. Instead they were programmed by making a
pattern of holes in a long paper tape that was read by the computer.
WARNING:
CHOKING HAZARD - Small parts.
Not for children under 3 years.
TO PARENTS: PLEASE READ THROUGH THESE
INSTRUCTIONS BEFORE PROVIDING GUIDANCE
TO YOUR CHILDREN.
PLEASE SCAN THE QR CODE TO VIEW MULTI-LANGUAGE INSTRUCTIONS
Part A: Base, B: Gearbox Side x 2, C: Cover, D: Battery cover, E: Cylinder, F: Cylinder support, G: Beaters x 3, H: Boombox head, I:
Motor, J: Peg set x 2, K: Clutch assembly, L: Large compound gear, M: Small compound gear, N: Axles x 2, O: Eye x 2, P: Screws x
9.
Q: Wire cap x 2. Also required, but not included in the kit: a small crosshead screwdriver, two 1.5V AAA batteries.
©2020 4M INDUSTRIAL DEVELOPMENT LIMITED. ALL RIGHTS RESERVED.
E. SET UP YOUR DRUMMER ROBOT:
A
D
E
F
G
H
I
J
K
L
M
N
P
Q
O
B
C
X 2
X 2
X 2
X 2
X 3
X 9
1
2
3
4
2x2R (Extended Content)
Content
A
D
E
F
G
H
I
J
K
L
M
N
P
Q
O
B
C
X 2
X 2
X 2
X 2
X 3
X 9
1
2
3
4
2x2R (Extended Content)
Content
